Comments on: DIY shelf curtains! http://www.eleen.com/2008/08/diy-shelf-curtains/ good stuff * hand made Mon, 30 Jan 2012 01:21:52 +0000 hourly 1 http://wordpress.org/?v=3.2.1 By: Jae Dagdag http://www.eleen.com/2008/08/diy-shelf-curtains/comment-page-1/#comment-94322 Jae Dagdag Sat, 23 Jul 2011 23:15:56 +0000 http://www.eleen.com/?p=208#comment-94322 Can I get your designers contact? Can I get your designers contact?

]]> By: Jenette Zirkle http://www.eleen.com/2008/08/diy-shelf-curtains/comment-page-1/#comment-53661 Jenette Zirkle Wed, 19 Jan 2011 09:16:40 +0000 http://www.eleen.com/?p=208#comment-53661 Merely wanna say that this is extremely helpful, Thanks for taking your time to write this. Merely wanna say that this is extremely helpful, Thanks for taking your time to write this.

]]> By: tiger rice cooker http://www.eleen.com/2008/08/diy-shelf-curtains/comment-page-1/#comment-49181 tiger rice cooker Mon, 27 Dec 2010 12:57:25 +0000 http://www.eleen.com/?p=208#comment-49181 you've got great ideas from previous posters, i'll also add that you should frame the mirrors get some molding at the hardware store and use some construction glue to attach the molding to the mirror, this will save you a lot as opposed to buying a new one and get a new light fixture you’ve got great ideas from previous posters, i’ll also add that you should frame the mirrors get some molding at the hardware store and use some construction glue to attach the molding to the mirror, this will save you a lot as opposed to buying a new one and get a new light fixture

]]> By: brass shower rod http://www.eleen.com/2008/08/diy-shelf-curtains/comment-page-1/#comment-49178 brass shower rod Mon, 27 Dec 2010 12:51:33 +0000 http://www.eleen.com/?p=208#comment-49178 most have a flat spot on it put a wrench on it and turn out...if not use a pipe wrench .make sure you use teflon tape on the threads when replacing to the elbow or it will leak in the wall and you won't know it till the wall comes down most have a flat spot on it put a wrench on it and turn out…if not use a pipe wrench .make sure you use teflon tape on the threads when replacing to the elbow or it will leak in the wall and you won’t know it till the wall comes down

]]> By: norelco speed xl http://www.eleen.com/2008/08/diy-shelf-curtains/comment-page-1/#comment-49177 norelco speed xl Mon, 27 Dec 2010 12:43:50 +0000 http://www.eleen.com/?p=208#comment-49177 I suggest you replace the seats of the valves before you go any further...sounds as if the seats have been burred by long past due washer replacement...you will probably have to replace the washers again, for bad seats destroy them quickly...you will need a special tool to replace the seats, low cost, available at the plumbing section of your hardware store...but you must know the make of the faucet before you can buy new seats. Good luck I suggest you replace the seats of the valves before you go any further…sounds as if the seats have been burred by long past due washer replacement…you will probably have to replace the washers again, for bad seats destroy them quickly…you will need a special tool to replace the seats, low cost, available at the plumbing section of your hardware store…but you must know the make of the faucet before you can buy new seats. Good luck

]]> By: Shon Lemmonds http://www.eleen.com/2008/08/diy-shelf-curtains/comment-page-1/#comment-40796 Shon Lemmonds Thu, 18 Nov 2010 09:54:44 +0000 http://www.eleen.com/?p=208#comment-40796 those plastic shower curtains are very cheap and you can install it easily without sweat ~:: those plastic shower curtains are very cheap and you can install it easily without sweat ~::

]]> By: Concrete Molds · http://www.eleen.com/2008/08/diy-shelf-curtains/comment-page-1/#comment-39890 Concrete Molds · Sat, 13 Nov 2010 10:49:09 +0000 http://www.eleen.com/?p=208#comment-39890 aluminum curtains rods are much lighter than those steel rods that we previously used .`. aluminum curtains rods are much lighter than those steel rods that we previously used .`.

]]> By: Maria http://www.eleen.com/2008/08/diy-shelf-curtains/comment-page-1/#comment-20672 Maria Sun, 16 May 2010 12:30:14 +0000 http://www.eleen.com/?p=208#comment-20672 Hi Eleen! I was browsing your blog, which I love, and came to see this post. What a lovely shelf! I love the design! Where did you buy it? Cheers from Toronto Maria Hi Eleen!

I was browsing your blog, which I love, and came to see this post.

What a lovely shelf! I love the design!

Where did you buy it?

Cheers from Toronto

Maria

]]> By: chips zynga http://www.eleen.com/2008/08/diy-shelf-curtains/comment-page-1/#comment-18120 chips zynga Sat, 20 Mar 2010 07:16:29 +0000 http://www.eleen.com/?p=208#comment-18120 i was starting to assume i may perhaps end up being the sole student that thought about this, at the least at this point i recognize im not extreme :) i will be sure to find out more about some various other blogposts just after i get my morning caffeine in me, it really is tough to read without having my coffee, I was unbelivably late last evening enjoying zynga poker and after polishing off a few ales i finished up burning off all my zynga poker chips adios for now :) i was starting to assume i may perhaps end up being the sole student that thought about this, at the least at this point i recognize im not extreme :) i will be sure to find out more about some various other blogposts just after i get my morning caffeine in me, it really is tough to read without having my coffee, I was unbelivably late last evening enjoying zynga poker and after polishing off a few ales i finished up burning off all my zynga poker chips adios for now :)

]]> By: Irvin http://www.eleen.com/2008/08/diy-shelf-curtains/comment-page-1/#comment-6962 Irvin Wed, 07 Jan 2009 03:47:26 +0000 http://www.eleen.com/?p=208#comment-6962 i2a3LAYvdIScu i2a3LAYvdIScu

]]>